Mark, for example with a felt pen, the position of the eccentric bolt -arrow- in relation to the subframe. Remove bolt -arrow-. Remove the upper transverse link.
Installation
Install the upper transverse link to the vehicle and finger-tighten the bolts. The transverse arm mounting bolts can only be tightened after the suspension has been installed in a position corresponding to the size "A"! Screw the transverse link to the subframe and tighten the new nut. The eccentric bolt -arrow- must be positioned in relation to the subframe in accordance with the previously marked marks. Tighten bolt -1- for upper transverse link.
Instructions: Make sure that a washer is installed on the bolt of fastening to the wheel bearing housing. Attach wire -arrow A- for speed sensor to upper control arm. Install coil spring. Install the wheel and tighten the wheel bolts. Check the installation angles of the flask.
Tightening torques
| The upper paired lever to the wheel bearing housing. Use only new bolts and nuts, tighten only in the position corresponding to the curb weight | 130 Nm and tighten by 90° |
| Upper wishbone to subframe. Use only new nuts, tighten only in the position corresponding to the curb weight | 95 Nm. To tighten the nut, set the torque wrench -VAG 1332- to a tightening torque of 80 Nm. Tighten with this setting only with 18 mm socket -T10179- |
Visitor comments