Removing
Loosen the union nut. Remove tire pressure sensor -2- from rim.
Installation
Caution: Before installing the tire pressure sensor, clean the hole for the valve.
Insert the tire pressure sensor -2- with the O-ring and washer on it into the hole in the disc and press it in the places indicated by -arrows-. Press the tire pressure sensor -2- into the disc by pressing it in the places indicated by -arrows-. Screw the union nut -1- onto the tire pressure sensor from the outside of the disc.
Press the tire pressure sensor -1- into the disc by pressing it in the places indicated by the arrows - and tighten the union nut to 3 Nm.
Caution: Tighten union nut to the correct torque. Sealing washer -2- deforms slightly when tightened. The sealing washer must not be reused. The sealing washer and rubber seal must be replaced each time the sensor is removed and installed. It is forbidden to tighten the union nut, as this will damage the seal and may impair the tightness of the wheel.
Torque
| Union nut for tire pressure sensor | 9 Nm |
Visitor comments