Instrument cluster The following elements are built into the instrument cluster: Control unit in dash panel insert -J285- Immobilizer control unit -J362- Speedometer Tachometer Fuel gauge Coolant...
Symbols for warning lights in the instrument cluster Instructions: Depending on the vehicle equipment, various instrument clusters are installed. Therefore, the location of the control lamps may differ from that shown in the figure....
Front wiper The wiper motor control unit -J400- and the wiper motor -V- are designed as one unit. When replacing the wiper motor control unit -J400-, the code must first be read and coded...
Removal and installation of a forward screen wiper Deactivate the APS function. Wait until the levers return to their original position and turn off the ignition. Disconnect battery. Instructions: In order to remove the wiper...
Removing the wiper motor from the wiper trapezoid Pry rod -1- off crank ball head -arrow- using lever -80-200-. Turn crank -2- and remove four securing bolts -arrows-. Remove wiper motor with control unit -1- from wiper linkage....
Adjustment of the extreme position of the wiper blades Deactivate, since it is still active, the APS function. Wait until the brushes return to their original position and turn off the ignition. Adjust the initial position of the...
Removal and installation of frameless wiper blades Instruction: Do not interchange the driver and passenger side wiper blades when installing. Frameless brushes have a very low rigidity. To lift the wipers from the windshield,...
Removing and installing rain and light sensor G397 If the rain and light sensor -G397- removed from the retaining plate on the windshield (e.g. when replacing a windshield), is correct, the sensor can then be reinstalled. Store...
Windshield washer Instructions: Depending on the configuration, two versions of the reservoir for the windshield washer and the headlight washer can be installed. The illustration shows the...
Rear window wiper 1 - cap 2 - Nut, wrench 13 mm, 12 Nm 3 - Brush lead 4 - Gasket, observe installation instructions when installing 5 - Frameless wiper blade 6 - Nozzle, replace 7 - Rear wiper...
Removal and installation of a back screen wiper Removing the wiper arm Allow the leash to return to its original position. Disconnect battery. Pivot cap -1- of rear wiper upwards and unclip it. Loosen but do not unscrew...
Rear window washer 1 - Adapter, the place of disconnection of the passenger compartment wiring harness from the wiring harness in the tailgate 2 - Angle connector, connection to the rear washer...
Headlight cleaning system Every fifth time the windshield washer is used, the headlights are also cleaned by pulling the stalk toward the steering wheel for at least 1.5 seconds with the dipped beam or...
Main headlight with halogen lamps Instructions: Before starting work on the headlights, turn them off and remove the key from the ignition. In the presence of malfunctions, it is necessary to know how the lighting...
Correction of the installation position of the headlight Instructions: It is not necessary to remove the front bumper to correct the mounting position of the headlight. The illustrations show the right headlight. If, when checking the...
Replacing the Low Beam Bulb Instructions: The following illustrations show the replacement of the right dipped beam headlight bulb. Replacement of a lamp of the left headlight of a passing beam is made...
High Beam Bulb Replacement Instructions: The following illustrations show the replacement of the right high beam bulb. Replacing the pump for the left high beam headlight is done in the same way. Switch off...
Parking light bulb replacement Instructions: The illustrations show the replacement of the parking light bulb on the right headlight. Replacing the lamp of the left headlight of the parking light is carried out...
Replacing the front turn signal bulb Instructions: The illustrations show the replacement of the right front turn signal bulb. Replacing the front turn signal bulb on the left headlight is done in the same way....
Main headlights with gas discharge lamps The headlight range control motor may not be removed. In the event of a malfunction, the headlight must be replaced. Instructions: Always turn off the headlights and remove the...
Headlamps with gas discharge lamps and adaptive lighting Instructions: Check the factors that affect the headlight adjustment, if necessary, adjust the headlights. 1 - Cap 2 - Left-hand discharge lamp -L13- or right-hand discharge lamp...
Replacing the discharge lamp Note: The left-hand discharge lamp -L13- and the right-hand discharge lamp -L14- can be checked using the final control diagnosis of the onboard supply control unit -J519-. The...
Replacing the cornering light bulb Instruction: The illustrations show how to replace the cornering light bulb -L149- on the right headlight. Replacing the cornering light bulb -L149- on the left headlight is...
Replacing the front turn signal bulb Instruction: The illustrations show how to replace the front right turn signal bulb -M7- on the right headlight. Replacing the front left turn signal bulb -M5- on the left...
Parking light bulb replacement Instructions: The illustrations show the replacement of the parking light bulb on the right headlight. For the right headlight, the replacement is similar. Switch off the ignition...
Control unit for cornering light and headlight range control The headlight range control control unit -J431- is bolted to the base housing of the tunnel support between the storage compartment and the center console on the driver's side....
Vehicle ride height sensor The rear left vehicle level sender -G76- is located on the left side of the rear axle. Removing and installing rear left vehicle level sender -G76- Switch off the ignition and all...
Fog lights 1 - Front bumper 2 - Fog light housing 3 - Mounting bolts, 1.5 Nm 4 - Left fog light bulb -L22- or right fog light bulb -L23-. Lamp H11 12 V, 55 W Instructions: Depending on the...
Back light (SBBR) in the side of the body Fault recognition and error indication The onboard power supply management system is equipped with a self-diagnostic function that makes it easier to find errors. For...
Rear lights (SBBR) in the tailgate Fault recognition and error indication The onboard power supply management system is equipped with a self-diagnostic function that makes it easier to find errors. For...
Additional brake lights Removing and installing auxiliary brake light bulb -U25- Instruction. Failure of the LED in additional brake lights. The individual LEDs in the additional brake light are combined...
License plate light Removing and installing license plate light -X- Switch off the ignition and all electrical consumers, remove the ignition key. Unscrew securing screws -arrows- for number plate...
Reversing lights in bumper cover Removing and installing left reversing light -X1- or right reversing light -X2- The left reversing light -X1- or the right reversing light -X2- are located in the lower section of...
Side marker lights Removal and installation of a forward lateral dimensional lantern Instructions: Removal and installation of the side marker lamp is carried out without removing the front bumper...
Understeering's shifter Caution: Removal and installation of individual components of the steering column switch must be carried out in the prescribed sequence. After installing the new steering column...
Ignition and starter switch and lock cylinder Removal and installation of the steering column stutter housing Instruction: To remove the steering column lock housing, you must first remove the steering column switch bracket....
Rear parking aid (PDC) 1 - Rear warning buzzer -H15-, behind the right side luggage compartment panel 2 - Rear parking aid control unit, on vehicles without front PDC or rear PLA: behind the right side...
Front parking aid (PDC) PDC Front Parking Assist System (Park Distance Control) assists the driver in maneuvering and parking by signaling the distance to an obstacle in front of the vehicle using...
Gap parking assistant (PLA) Gap parking assistant (APP (PLA)) assists the driver when reversing into a parallel parking space on the driver's or front passenger's side. When the clearance assist is activated...
Rear View Camera 1 - Control unit with display unit for radio and navigation system -J503-. Fitting location: Front in the center console 2 - Reversing camera system control unit -J772-. Fitting...
Lamps and switches internal Instruction: When removing and installing elements that are in sight (switches, covers, facing pashas, etc.), seal the points of use of the tool, wedge -VAS 3409-, screwdriver,...
Lights and switches in the front doors Removal and installation of the switch module on the driver's side The following items are built into the driver's side switch module (depends on configuration). Mirror adjustment...
Lights and switches in the rear doors Removing and installing rear left power window switch -E52- or rear right power window switch -E54- Switch off the ignition and all electrical consumers. Remove door trim. Release...
Lighting and switches in the trunk Removing and installing luggage compartment light -W3- Instructions: The luggage compartment light is located in the left side trim of the luggage compartment. Switch off the...
Lighting and switches in the upholstery of the ceiling Ceiling lamps for general and individual interior lighting (car without panoramic sunroof) The following components are installed in the ceiling lamps for general and individual...
Lights and switches in the center console Removing and installing the button in the center console compartment Instructions: The switches in the center console are located in the switch box. Removal and installation for...
Sound signal Removing and installing high-frequency horn -H2- and low-frequency horn -H7- Note: The high frequency horn -H2- and the low frequency horn -H7- are controlled in parallel by the...
Inmobilizer The Tiguan is equipped with a fourth generation immobilizer with online connection and download. The most important part of the fourth generation immobilizer with download is the...
Anti-theft alarm (DWA) The anti-theft alarm functions are integrated in the convenience system central control unit -J393-. Fault recognition and error indication The anti-theft alarm is equipped with a...
Fuse and relay boxes The fuse box is located under the storage compartment in the footwell on the driver's side. Removal and installation of the fuse box The fuse box is located under the dash, in the...
Switching blocks Removal and installation of the switching block in the left part of a motor compartment Instruction: At present, only the switching unit of the version "Low". The following...
Control units Onboard supply control unit -J5J9- The onboard supply control unit -J519- -arrow- is located on the left under the dash panel on the left above the fuse box. Note: The onboard...
U1 cigarette lighter The following descriptions also apply to rear left cigarette lighter -U3-, rear right cigarette lighter -U7-, rear cigarette lighter -U9-, 12 V socket 2 -U18-, 12 V socket 3...