Removal and installation of a starter
Disconnect battery. Remove engine cover -arrows- towards top.
Unlock and disconnect electrical connector -1- and loosen spring clip -2- with pliers -VAS 5024A- and detach vacuum hose -3-.
Unscrew the screw securing the air filter housing -arrow-
Release latches -arrows- and remove cover.
Detach hose -arrow- from air cleaner housing and pull it out of vehicle. Release the air filter housing from the rubber mounts upwards and remove it.
Pull the protective cap off the solenoid in the -arrow- direction.
Unscrew positive wire -1- and disconnect terminal 50 connector -2-.
Loosen upper securing nut -1- of cable holder -2-. Remove soundproof cover.
Unscrew the bottom nut -2- of the wire holder and remove the wire holder -1- from the threaded ends of the starter fastening screws.
Remove lower starter bolt -arrow-.
Unscrew upper starter bolt -arrow-. Remove the starter from the vehicle by moving upwards.
Installation is carried out in the reverse order. Tighten screw connections to the specified tightening torques.
Visitor comments