CSTA, CCTV
Disconnect connector for lambda probe -G39- -arrow- and move wiring clear.
All
Unscrew accessible nuts -arrows- from exhaust exhaust pipe to turbocharger from above.
Four-wheel drive
Unscrew propshaft from bevel gear and secure on right.
All
Unscrew accessible nuts from below for connecting exhaust pipe to turbocharger. Unscrew nuts -arrows- and pull floor trim downwards slightly.
CAWA, CAWB, CSTA, CCTV
Unplug electrical connector -arrow- on right side of floor. Remove the electrical connector from the holder and release the electrical cable to the lambda probe.
All
Unscrew bracket for exhaust system -arrows-.
Remove front floor cross member -arrows-.
Caution: Risk of damage to detachable elements. The split elements in the downpipe must not be bent more than 10°.
Loosen the clamp -1 - with me and move it back. Remove catalytic converters with exhaust pipe.
Install in reverse order, paying attention to the following. Apply heat-resistant paste -G 052112 33- to the threads of the locating pins of the turbocharger. Replace gaskets and self-locking nuts. Tightening torque: tunnel cross member to body: 25 Nm.
Visitor comments