- 1 - Switch drive cover with handle. Emergency release: before removing the handle, remove the button through the pressure point and secure with adhesive tape. In this way, accidental pressing of the button into the handle can be avoided. If the button is to be installed with the handle dismantled: be sure to pull out the button before installation, bypassing perceptible resistance
- 2 - Switching drive with selector
- 3 - Bolt with spring, 3 Nm
- 4 - Bolt, do not lubricate
- 5 - Protective screen, always replace when disassembling.
- 6 - Nut, 9 Nm, 4 pieces
- 7 - Control lever support housing with seal
- 8 - Selector rod, do not additionally lubricate the rod
- 9 - Hexagon nut with washer, 8 Nm, 4 pieces
Visitor comments