Repair of the clutch release mechanism

• 1 - Gearbox
• 2 - Lip seal of the input shaft
• 3 - A working cylinder with a release bearing, they form a single unit and are replaced only as an assembly, do not wash the bearing, just wipe it, if the bearing is noisy, replace it together with the working cylinder, for some working cylinders the pipeline is made of composite
• 4-Bolt, always replace, 3 pcs., 15 Nm
• 5 - O-ring, put on the pipe fitting, lubricate with brake fluid during installation

Slave cylinder -A- with integral piping

For some working cylinders, the piping is designed as a composite -arrow-.