Open the hood and prop it up.
Insert a small screwdriver under spring clip 2.
Raise the spring clip 2 so that it can be moved from the ball bearing in the direction.
Remove gas stop 1 from ball pins 3 and 4.
After removing the gas stop 1, immediately move the spring clip 2 in the opposite direction.
CAUTION: When using the gas stop, handle it carefully. The spring clip must not be removed completely from the ball bearing, otherwise it may be damaged. The gas stop may pop out of its mount, causing damage to the gas stop itself and possible injury.
Tightening torques: ball pin 20 Nm.
Visitor comments