Removing
Remove the front right seat.
If so, remove the seat frame trim.
First you need to check if the radio with encoding is installed in the car. If yes, then you should find out the security code.
Switch off the ignition and all electrical consumers, remove the ignition key.
Disconnect the battery ground wire.
Disconnect plug connection 1 for transfer case control unit J646 and, if necessary, plug connection 2 for automatic transmission control unit. gearboxes J217.
Remove screw 3 (pic. 3.93).
Pull the holder with transfer case control unit J646 in the direction of the arrow from the holder on the seat frame.
Press the latches 1 in the direction of the arrow and remove the transfer case control unit J646 from the holder (pic. 3.94).
When doing this, make sure that the transfer box control unit J646 does not fall out.
Installation
Installation is carried out in the reverse order, paying attention to the following.
Insert holder for transfer case control unit J646 with trims 2 into stops 1 on the seat frame (pic. 3.93).
Tighten bolt 3 to 8 Nm.
Connect the mass cable to the battery and carry out operations to connect the battery.
Visitor comments