(1) brake cylinder
(2) retracting springs. To install correctly, the long arms of the springs must face the cylinder.
(3) pressure rod with bushing and adjusting gear. Left rear wheel - right hand thread, right rear wheel - left hand thread. The bevel on the sleeve and the longer trunnion on the rod look towards the metal sheet.
(4) brake pad with lining. Lining thickness 6 mm, oversize 6.5 mm, wear limit 2.5 mm.
Note: Lightly grease the threads of the pressure rod, the brake pad webs, the brake lever of the pad and the contact surfaces of the pads with molybdenum paste G.
Attention! Brake linings should be replaced all at once on one axle. Apply overlays of the same quality.
Visitor comments