(1) wheel support
(2) washer
(3) guide rod. Setting the convergence and camber
(4) external bearing for guide rod with elongated camber holes
(5) inner bearing support for guide rod with horizontal elongated holes for setting the toe
(6) rubber-metal bearing
(7) lower lining for the helical spring. The contours from the end of the spring on the lining and on the rod must match
(8) cardan shaft
(9) hex bolt with lock washer
(10) shock absorber bearing
(11) shock absorber (in various designs)
(12) rubber bushing
(13) steel sleeve
(14) screw spring. Spring designation; for a van, 1 or 2 yellow dashes; for a bus, 1 or 2 green dashes. The number of colored dashes indicates the load group. Only one group of springs can be installed on one axle (with the same number of colored lines)
(15) thrust buffer
(16) support for the helical spring. Turn so that the end of the spring lies in the recess
(17) support for additional spring
(18) helical spring support
Visitor comments