Electrical equipment and devices of car VW Transporter T3

Control devices — design description
The control devices of the bus are located on the control panel. The control panel insert can be completely dismantled. (1) remote control insert (2) casing with control lamps (3)...

Dismantling and installation of the control panel
Dismantling Disconnect the battery from the ground. (90-294) grasp the grooves with both hands (arrows) and lift up the cover of the control panel. (90-295) remove the alarm...

Dismantling and installation of the speedometer shaft
Dismantling Remove the control panel cover, see above. Disconnect the battery from the ground. Loosen the union nut on the drive shaft at the speedometer. Raise the front of the...

Switches on the steering column
(1) cap. Remove by hand (2) disengaging ring with slip ring. Lubricate the contact ring with universal grease. Replace defective slip ring (3) turn indicator knob. Set the...

Removal and installation of switches on the steering column
Dismantling Disconnect the battery from the ground. Remove steering wheel, see " Dismantling and installation of the steering wheel ". (94-233) unscrew the top and bottom of the...

Dismantling and installation of the antenna
Dismantling Disconnect the battery from the ground. Dismantle the control panel see above . remove the ashtray from the control panel upwards: (90-308) remove antenna plug...

Windshield washer and headlight washer
Rotary pumps for windshield washer and headlight washer (advanced equipment) located on the common windshield washer tank. When replacing hoses, fasten the new hoses, like some,...

Windshield washer nozzle adjustment
Using a pin, adjust the nozzles as shown in the figure.

Replacing the rubber nozzles of the wiper blade
Remove the wiper blade.. From the closed side of the rubber nozzle, compress both steel slats with pliers (see picture); release from the upper clip and pull the rubber together...

Dismantling and installation of the wiper brush holder
Dismantling Remove the cap from the wiper shaft with a screwdriver. Unscrew the hex nut, remove the brush holder. Installation (92-309) install the brush holder so that the wiper...

Table of malfunctions of wiper blades
Table of malfunctions of wiper blades

Dismantling and installation of the wiper
(1) wiper motor (2) wiper frame and rods (3) brush (4) brush holder (5) automation relay (6) lubricate with molybdenum grease (7) rubber (8) adjust deviation Dismantling...

Wiper malfunction table
Fault: The engine does not rotate in the 1st stage or does not rotate at all. Attention! The troubleshooting instructions are only valid for vehicles without automatics. Test...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Transporter T4 Transporter T3