Attention: Hand over the oil to special waste collection points. At the gas station, used oil is accepted back at the expense of buying a new one. In addition, the address of the nearest waste oil collection point can be found in the city or village administration. Under no circumstances should the old oil be thrown out and disposed of with household waste.
Warm up the engine to operating temperature (oil temperature 60°C).
Substitute a container to collect the old oil.
Unscrew the oil drain plug and drain the oil completely.
Then screw in the plug with a new seal and tighten it gently, tightening torque 25 Nm.
Pour in new oil through the oil filler neck.
Filling capacities:
- Without filter change 4.0 liters
- With filter change 4.5 liters
The difference in the volume of oil to be filled between the marks "min" And "Max" is 1 litre.
After a test drive, check the tightness of the connection between the oil plug and the oil filter, tighten carefully if necessary.
To control the performance of the engine, it is best to fill in oil of the same type and brand. Therefore, it is recommended to install a nameplate on the engine with the type and viscosity of the filled oil printed on it.
The indiscriminate use of different types of oil is not recommended. Engine oils of the same type, but different brands, if possible, it is better not to mix. Engine oils of the same type and brand, but of different viscosities, can be mixed without restrictions if necessary, for example, when the season changes.
Visitor comments