Exterior elements of car body VW Transporter T4

General information about the car body
VW T4 has a self-supporting steel body. The bottom, roof, fenders and side parts are spot-welded to each other. Therefore, large damage to the body can be eliminated only at the...

Bumpers — removal and installation
Removal and installation of a forward bumper 1. Plug; 2. Hex bolt; 3. Washer; 4. Front bumper; 5. Pins; 6. Guide piece; 7. Sealing washers Removal and installation of a back...

Front closing beam — removal and installation
The front end beam is bolted on and, in case of damage during an accident or repair, can be easily removed. Removing 1. Remove the bottom guard (protection) engine compartment. 2....

Bonnet cover — removal and installation
Removing 1. Unscrew 3 Phillips screws (2). Carefully lift and remove the grate (1) (3 - expansion nuts). 2. Disconnect the hose from the glass washer water jets, release it from...

Radiator grill — removal and installation
Removing 1. Open the bonnet. 2. Unscrew cross screws (1). Pull out the radiator grille (2) forward and remove from the lower support holes. 3. If necessary, disassemble the grille...

Protective bar for license plate light
Removing 1. Remove the inner lining of the trunk lid by unscrewing the clips with a 3 mm hex socket wrench. 2. Unscrew the lentil screws from the inside (2). Unscrew cross screws...

Outside mirror — removal and installation
Removing 1. Unscrew 3 screws (2) fixing the mirror while holding the mirror (3). 2. In the case of an electrically adjustable mirror, disconnect the plug at the top front of the...

Replacement of exterior mirrors
1. The mirror glass sits in a framed housing and can be removed without removing the mirror from the car. 2. Remove the glass from the frame with a wide plastic spatula, first...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Transporter T4 Transporter T3