Vehicle owner's manual VW Transporter T4

Bulkhead modifications
On the left is the station wagon. Bulkhead at half the height of the opening, padded along the top edge. On the right is a blind bulkhead *. On the left is a full opening bulkhead...

Vehicle dimensions
Van Base 2920 mm Base 3320 mm Body with hinged tailgate Body with hinged rear doors Tall Van Base 2920 mm Station wagon Flatbed truck Base 3320 mm Body with hinged tailgate...

Replacing the rubber blades of the wipers
Rubber tabs are replaced if they leave streaks on the glass. In the distribution network, you can purchase both wipers with rubber petals installed, as well as individual rubber...

Glass washing jets — removal, installation and adjustment
Removing 1. Unscrew the air grille screws on the hood cover, fold the grille forward. 2. Press the jet stopper to the side with a screwdriver and remove the jet. 3. Disconnect the...

Headlight cleaning system
Headlight Sprayer Adjustment Dimensions Left headlight Jet adjustment dimensions: a = 120 mm, b = 50 mm. In factories, a special tool VW-3019A is used for adjustment. Before...

Wiper drive device
Wiper device 1. Windshield wiper (street cleaner); 2. Lever; 3. Protective cap; 4. Hex nut, 16 Nm; 5. Washer; 6. Hex nut, 5 Nm; 7. Rubber nozzle; 8. Distance sleeve; 9. Screw, 25...

Wiper motor — removal and installation
Windshield motor The arrow indicates the screw hole of the handle lever. Rear window motor with wide tailgate The arrow indicates the screw hole of the handle lever. Rear window...

Glass washing water pump — check and replacement
Examination 1. Turn off the ignition and turn on the washer with the power lever. If water does not splash onto the windshield, disconnect the plug. 2. Connect a voltage indicator...

Diagnostics of malfunctions of janitors
Cause Elimination Method Mucus marks on glass Contaminated rubber Clean the rubber petals with a stiff nylon brush and detergent water or alcohol Rubber fringe, rubber cracked or...

Car wash
Wash the car, if possible, without delay, immediately after the trip. Before washing the car, first soak the traces of insects, then rinse with water. Wash with plenty of water....

Care of the lacquer coating
Conservation Treat the clean, washed lacquer surface with a preservative as often as possible to protect it with a pore-smoothing and water-repellent layer of wax from...

Care of plastic parts
Plastic parts, imitation leather seats, ceiling lamps, lamp diffusers and parts with a matt black finish can be cleaned with water and shampoo. The plafond must not be wetted...

Glass cleaning
Wipe glass inside and out with a clean, soft cloth. With severe pollution, alcohol or ammonia and warm water, as well as a special glass cleaner, help. Tilt the wipers forward...

Caring for rubber seals
From time to time coat rubber, sealing surfaces or rubber sliding surfaces with talcum powder or silicone spray to maintain its elasticity. With these tools, you can also get rid...

Caring for aluminum rims
Treat with a rim cleaner, especially in the cold season, but never use an aggressive, acidic, strongly alkaline or abrasive cleaner, or a steam jet with a temperature above +60°C.

Seat belts
Clean only with a mild soapy solution when installed, do not use chemicals, otherwise the fabric of the belt will be damaged. Wind up automatic belts only when dry. If necessary,...

Bottom protection and preservation of axle shafts
The rear wheel wells as well as the side members in the area of the driver's door are covered with PUC underbody protection. Areas subject to stone impacts, for example in the...

Upholstery care
Fabric upholstery The fabric upholstery is cleaned with a vacuum cleaner or a not too soft brush. Grease and oil stains are treated with gasoline or stain remover. The cleaning...

Starting the engine from another source
Connecting Starter Cables A. Battery (discharged) B. Donor battery 1. The cross-section of starter cables for gasoline internal combustion engines with a working volume of up to...

Towing a car
Towing eyes are located in front and behind the cars under the bumpers. When towing, turn on the ignition so that the steering wheel does not jam and you can use the direction...

Putting the machine on stands
For many jobs, the machine must be placed on stands or raised high. In factories, as a rule, the machine is lifted by a lifting platform. However, it can also be lifted with...

Vehicle identification
The engine number and letter designation are stamped on the cylinder block above the oil filter: 5-cylinder gasoline engine - on the cylinder block between 2 and 3 cylinders;...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Transporter T4 Transporter T3