Windshield motor
The arrow indicates the screw hole of the handle lever.
Rear window motor with wide tailgate
The arrow indicates the screw hole of the handle lever.
Rear window motor (double door)
The arrow indicates the screw hole of the handle lever.
The electric motor can only be removed together with the system of levers, rods and bracket. The instructions apply to windshield wipers of any glass.
Removing
1. Switch off the ignition.
2. Let the wipers run for 2 minutes and turn off the wiper switch. In this case, the wipers return to their original, non-working position.
3. Switch off the ignition.
4. Disconnect ground cable (-) from the battery.
Attention! At the same time, the anti-theft code is erased from the radio's memory. The battery must only be disconnected when the ignition is switched off, otherwise the injection system control unit will fail.
5. Disconnect the wiper arms and remove from the axles, first removing the protective caps with a thin screwdriver.
6. Unscrew the wiper frame by unscrewing the screw (9) (see fig. Wiper device) and take it out together with the electric motor.
7. Remove from the handle lever of the drive rod (10).
8. Disconnect the motor from the wiper frame by unscrewing the 3 screws.
9. Unscrew the handle lever from the motor shaft.
Installation
1. If a new engine is to be installed, put it in idle position before installation. To do this, connect the multi-pin connector and let the engine run. Then turn it off with the wiper switch - the engine will take a non-working position. Disconnect the multi-pin connector.
2. Install the handle lever and adjust so that its lower edge coincides with the indicated screw hole (see fig. Windshield motor, fig. Rear window electric motor with wide trunk lid and fig. Rear window motor (double door)).
3. Tighten the handle lever to 30 Nm.
4. At the windshield wiper motor, put the drive rods on the handle lever.
5. Install the engine together with the wiper frame and screw with a torque of 25 Nm.
6. Connect ground cable (-) to the battery.
Attention! Connect the battery only when the ignition is switched off, otherwise the injection control unit may be damaged.
7. Set clock time.
8. Enter anti-theft radio code.
9. Connect the multi-pin connector and turn on the engine, let it run to the idle position.
Windshield wipers
10. Install the wiper arms on the axle so that the wipers take the position marked on the windshield with markings. Tighten levers to 10 Nm. (a - marking for a left-hand drive car, b - marking for a right-hand drive car (export models)).
Rear window wiper
11. Set the wiper to the height of the lower thread of the heated rear window heating, a = 45 mm. If equipped with a double-leaf door, install the wipers so that they are vertical in the non-working position.
12. Put on protective caps.
13. Check the work of the wipers.
Visitor comments