Removing
1. Moisten the nuts on the clamp between the center muffler and the exhaust muffler with the exhaust pipe with rust remover and leave for a while until the agent takes effect and the nuts are clear.
2. Unscrew the clamp, remove the exhaust silencer with the exhaust pipe from the rubber support forward. If there is not enough space, unscrew the rubber support from the console.
3. Remove the exhaust silencer with the exhaust pipe from the center silencer by turning it from side to side.
4. If the muffler cannot be removed, there are various ways to remove it: Saw through the exhaust pipe at a distance of 10 cm from the clamp. Then saw the rest of the pipe lengthwise and knock it down with a hammer and chisel. If you have a gas burner at hand, heat the desired place.
Attention! Protect the bottom of the machine with asbestos.
Installation
1. Check that the clamping bolt, nut and rubber support are in perfect condition and replace if necessary.
2. Install the new exhaust muffler with exhaust pipe into the rubber support at the front.
3. Put on the clamp and connect the exhaust pipes together. pay attention to the size "A" from the edge of the pipe to the mark.
Attention! To facilitate subsequent disassembly, grease the thread of the clamping bolt and the insertion part of the pipe with heat-resistant paste.
4. Align the exhaust silencer, making sure there is sufficient distance from the body.
5. Tighten clamp.
Visitor comments